Registered: 1445603740 Posts: 3
Reply with quote #1
I have problems writing the right OSCCAL value to a
PIC16F630 with my K150. First I read out the new blank PIC16F630. The OSCCAL value was 3428. After that I loaded the hex file into MicroBrn. I edited the last value (dooub clicking on it) from 3FFF to 3428 and programmed the PIC with that modified hex. After that I read the PIC16F630 out again. The OSCCAL Value shows 34FF now. So at the moment I do not understand why there is the wrong value?
Registered: 1122801962 Posts: 1,890
Reply with quote #2
This forum is for people who purchase
DIY programmers, not pirate copies. If you are having problems then ask the reseller. genuine Having said that, the programmer works fine with a lot of PICs however they do have known bugs (see readme file in the install folder). Development of these programmers stopped long ago so these bugs will not be fixed.